1/1

Bringing fabrication to the fight

U.S. Air Force Senior Airman Robert Mason, 354th Maintenance Squadron metals technology journeyman, uses a caliper to measure aluminum while fabricating a part for an F-16 Fighting Falcon at Eielson Air Force Base, Alaska, July 22, 2013. Commonly, a part for an aircraft can’t be purchased or is just cheaper to produce. Metals tech Airmen can fabricate almost any part or tool from raw material. (U.S. Air Force Senior Airman Shawn Nickel/Released)

PHOTO BY: Unknown
VIRIN: 130722-F-FT438-003
FULL SIZE: 1.5 MB
Additional Details

No camera details available.

IMAGE IS PUBLIC DOMAIN

Read More

This photograph is considered public domain and has been cleared for release. If you would like to republish please give the photographer appropriate credit. Further, any commercial or non-commercial use of this photograph or any other DoD image must be made in compliance with guidance found at https://www.dimoc.mil/resources/limitations, which pertains to intellectual property restrictions (e.g., copyright and trademark, including the use of official emblems, insignia, names and slogans), warnings regarding use of images of identifiable personnel, appearance of endorsement, and related matters.

Go to Gallery